F-l: EXTENDING TRACK FRAME GAUGE WIDTH (only when divided into three parts for transportation) Tools and facilities required Part Name Q3.Y Power wrench xl 2 or xl 6 I 1 Torque wrench (50 kgm) I 1 Socket for x12 25.4’ x 60 I 1 Socket for x16 38.1” x 60 I 1 Hydraulic jack I 2 Precautions After extending the gauge width, check there is no interference with the travel motor or twisting of the piping. Extending gauge width 1. Remove center frame mounting bolts @ (front and track frame on the side to be extended. rear, one side x 12) at the front and rear of the Mounting bolt: 21 N-30-1 1190 x 12, 60 mm, length: 125 M39 x 3, width across flats: Spacer: 21N-30-11170x 12 Outside diameter:
77 mm, height: 45 mm 2. Swing the work equipment to face at right angles to track frame @ on the opposite side to the side * When raising the track frame, keep height H to to be extended. less than 50 mm. If the track frame is raised too high, the stopper bolt will be twisted and the bolt will bend. 3. Using the arm, pull the machine forward to slide the track frame. Ct? fra 4. Extend the track gauge until it contacts the stopper, then lower the machine to the ground slowly and tighten bolts@ (front and rear on each side x 30). * Tightening torque: 335 + 35 kgm Bolts @and @ are the same bolts. 5.
Repeat the same procedure for the track frame on * Carry out the operation for extending or retract- the other side. Mounting bolts (Parts sent individually) ing the track frame gauge width on firm level No. ( Part No. I Part Name I Q-Y * When extending or retracting the track frame ground. 1 21 N-30-1 1190 Bolt 36 gauge width, it is dangerous to move the cyl- inder suddenly, so never do this. 2 2 ‘I N-30-1 1170 Spacer 36 148