G. CHECK OF ALL PARTS DURING AND AFTER ASSEMBLY CHECK OF ALL PARTS DURING AND AFTER ASSEMBLY WlTH FIELD ASSEMBLY INSPECTION REPORT Check for loose nuts and bolts, tighten them if they are loose. Check all parts for loose nuts and bolts, and tighten Be particularly careful to check the following parts. - Track roller * Sprocket teeth * Engine * Pumps * Swing circle * Swing machinery * Travel motor Check for leakage of water and oil Walk around the machine and check for any signs of oil or water leakage. Be particularly careful to check the following parts.
+ High pressure hoses and piping joints * Hydraulic cylinders l Floating seals at rotating parts of undercarriage * Area around radiator * Area around engine loose terminals Check electrical wiring for disconnections, short circuits, tions or short circuits. Check also for loose terminals Check the electrical wiring for any signs of disconnec- and tightn them if they are loose. Be particularly careful to check the wiring of the follow- ing parts. - Battery l Starting motor * Alternator Drain water and sediment from fuel tank Loosen valve @at the bottom of the tank, and drain the water and sediment collected at the bottom together with the fuel.
Check operation of air conditioner Check operation of working lamp (See operation manual) Check operation of wiper Check central warning monitor To prevent failure of the central warning monitor to give warning because of broken lamp bulbs or buzzers, carry out the following checks. 1. Turn the starting switch to the ON position before starting the engine. and the alarm buzzer should sound. All the monitor lamps should light up for 3 seconds 152