A-3: POINTS REGARDING LOCAL ASSEMBLY 1. Selection of work place 1) The work place should be suitable for loading and unloading the machine. The following points should be considered. l Hardness of ground surface l Area l Levelness 2) Assembly work on the hydraulic circuit must not be carried out in any place where dust or rain can get into l Entry/exit roads, turning space 3) If the work is carried out outside, avoid places where there is rain or strong wind. the circuit during the operation. 2. Preparation and checks of lifting tools and jigs 1) Check each lifting tool and jig thoroughly. In particular, check stands and blocks made of wood to check that the inside is not rotted or cracked.
3. A 1) 2) Checks during actual operation Apply the parking brake of the trailer and crane securely, then put blocks under the wheel. 3) When starting the engine, always give an agreed signal, such as blowing the horn, to warn the people around Lower the pressure and temperature of the engine, hydraulic oil, and cooling water before starting work. trol lever is at the low idling position. the machine. Check also that the work equipment levers and travel levers are in neutral, and that the fuel con- 4) Be careful to maintain the balance of parts being lifted by the crane. 5) Do not allow unauthorized persons into the working area. 25