POWER TAKE OFF 00-19 Notice: Tighten the bolt after having adjusted it in accordance with the work procedure of the “Control Cable Adjust- ment”. NPA0037E Legend 1. Rod end ball portion 2. Control cable 3. Cable holder NPA0039E Coat the rod end ball of the cable tip with a small amount of grease and assemble it in the groove of the control cable connector on the PTO side. Legend 1. Cable holder 2. Lock nut 3. Special nut 4. Bolt 5. PTO 3. Special Nut Tighten the special nut to the cable holder at a specified torque pressing down the control ca- ble to the PTO side lightly. Tighten: Special nut to 147 N m (15 kg m / 108 lb ft) NPA0038E Legend 1.
Rod end ball (apply a small amount of grease) 2. Cable holder 3. Cable connector 4. Shift rod 5. PTO Install the cable holder in the PTO and tempo- rarily tighten the bolt. NPA0040E