00-30 POWER TAKE OFF 4. After having adjusted the control cable, slowly op- erate the dump lever twice or three times and re- check the spool extrusion dimension. (Refer to the item of Measurement of The Amount of Spool Extrusion.) NPA0065E Legend 1. Control cable 2. Cable holder 3. Oil pump portion 4. Bolt 5. Special nut 6. Outer threaded portion 7. Lock nut 8. Truck rear NPA0067E 5. After having completed all measurement and ad- justments, set the dump lever to the “Down” posi- tion and start the engine.
Operability of the Dump Lever, Rise of the Body (Cargo Deck), and Inspection and Adjustment of the Rise and Fall Reference Times 5) After having tightened the special nut, tighten the lock nut at a specified torque. 1. Check that the engine revolution per minute is 1,250 rpm and the rise and fall operations of the body (cargo deck) are performed within the follow- ing reference times. Rise time = within 20 seconds Fall time = within 20 seconds 2. Inspection of the dump lever control force and moderation Tighten: Lock nut to 20 N m (2.0 kg m / 14 lb ft) Inspect that the operation of the dump lever can lightly and smoothly be performed.
Basic value = less than 10 kgf (98 N) on the dump lever knob When the dump lever is in the “Up” and “Down” positions, inspect that the lock operation can be performed without a feeling of physical disor- der. 3. After having repeated the “Up” and “Down” posi- tions of the dump lever and slowly set them to the “Down” position as much as possible, inspect the shaft (driving shaft) between the PTO and oil pump. NPA0066E Legend 1. Special nut 2. Oil pump portion 3. Lock nut Inspect that the shaft (driving shaft) rotates for- ward or backward. If the shaft slowly rotates backward, it is nor- mal.