Carburetor Float Bowl Drain (350) Oil Level Stick ATV-0100AA AF925 Periodically, the float bowl should be drained to remove condensation. To drain the float bowl, use the following proce- dure. 1. Direct the hose from the float bowl drain into a container. ! WARNING Do not drain float bowl contents directly onto the engine. Gasoline is highly flammable and could ignite. Use a hose. 2. Loosen the drain screw and allow the gasoline and condensation to flow out. 3. Tighten the drain screw securely and remove the hose. ! WARNING into the engine case. It is very important that the drain screw be tightened securely. If it is not tightened securely, gasoline could drip onto the engine. 3.
Remove the oil level stick; the engine oil level should be above the “L” mark but not higher than the “F” mark. Electric Fuel Pump (425) An electric fuel pump is incorporated in the gas tank to deliver gasoline to the fuel injector. The fuel pump is activated when the ignition switch is in the ON position. NOTE: Both the ignition and fuel pump functions will be interrupted by the Tilt Sensor if the ATV tips over past 60°-70°. Righting the ATV will reactivate the ignition and fuel pump. CAUTION Do not overfill the engine with oil. Always make sure the oil level is above the “L” mark but not higher than the “F” mark.
43 43 43 43 KC0051A There is an oil level stick for checking the engine oil level. To check the oil level, use the following procedure. NOTE: The ATV should be on level ground when checking the engine oil level. 1. Unscrew the oil level stick and wipe it with a clean cloth. Division II - Operation/ Maintenance