6. If using the CTEK XS 800, there are no further buttons to push. If using the CTEK MXS 3600, press the Mode button (A) at the left of the charger until the Maintenance Charge Icon (B) at the bottom illu- minates. The Normal Charge Indica- tor (C) should illuminate on the upper portion of the battery charger. NOTE: The sealing strip should NOT be removed and NO fluid should be added. 2. Be sure the charger and battery are in a well-ventilated area. Be sure the charger is unplugged from the 240- volt electrical outlet. 3.
Connect the red terminal lead from the charger to the positive terminal of the battery; then connect the black terminal lead of the charger to the negative terminal of the battery. 4. Plug the charger into a 240-volt electrical outlet. 5. By pushing the Mode button (A) on the left side of the charger, select the Normal Charge Icon (E). The Nor- mal Charge Indicator (C) should illuminate on the upper left portion of the charger. 800A 6. The battery will charge to 95% of its capacity at which time the Mainte- nance Charge Indicator (D) will illu- minate. NOTE:
For optimal charge and per- formance, leave the charger con- nected to the battery for a minimum 1 hour after the Maintenance Charge Indicator (D) illuminates. If the bat- tery becomes hot to the touch, stop charging. Resume after it has cooled. NOTE: The maintainer/charger will charge the battery to 95% capacity at which time the Maintenance Charge Indicator (D) will illuminate and the maintainer/charger will change to pulse/float maintenance. If the battery falls below 12.9 DC volts, the charger will automatically start again at the first step of the charge sequence. 3600A 8. Once the battery has reached full charge, unplug the charger from the 240-volt electrical outlet. NOTE:
If, after charging, the bat- tery does not perform to operator expectations, bring the battery to an authorized Arctic Cat dealer for further troubleshooting. NOTE: Not using a battery char- ger with the proper float mainte- nance will damage the battery if connected over extended periods. Charging NOTE: Arctic Cat recommends the use of the CTEK XS 800 or the CTEK MXS 3600 for battery mainte- nance charging. 1. Be sure the battery and terminals have been cleaned with a baking soda and water solution. 54 54 54 54