8. Clean any dirt or debris from inside the air cleaner. Be sure no dirt enters the carburetor. 2. Remove the drain bolt from the cover and allow the water to drain out. 3. Shift the range lever to the neutral position; then start the engine. 10. Connect the inlet boot and tighten the clamp securely. 9. Install the air filter and cover. 4. Increase and decrease engine RPM several times to “blow out” any water; then stop the engine. 5. Install the drain bolt and tighten securely. NOTE: The V-belt and pulleys should be inspected every 500 miles and the belt replaced (if necessary). Tires KC0056B Always use the size and type of tires as specified.
Refer to the Specifica- tions chart for proper tire inflation pressure, and always maintain proper tire inflation pressure. ! WARNING Air Filter Housing Drain Inspect the “duck bill” drain in front of the main housing for debris and for proper sealing. Tire Tread Condition The use of worn-out tires on an ATV is very dangerous. A tire is considered to be worn out when the depth of the tread is less than 3 mm (1/8 in.). Be sure to replace the tires before reaching this min- imum specification. Draining V-belt Cover KC0056C 732-649A ! WARNING The use of worn-out tires is danger- ous and can increase the risk of an accident. KC0049A NOTE:
If the ATV has been driven through water, the V-belt cover must be drained of any water. 1. Place the ATV on a level surface. 58 58 58 58