1. Remove the two screws and remove the lens. NOTE: To remove the fuse, com- press the locking tabs on either side of the fuse cover and lift out. 2. Pull out the bulb. 3. Install the new bulb by pushing it in. 350 4. Install the lens. Tighten the two screws securely. Turn Signal Light - Rear/ Taillight/Brakelight To replace the turn signal light - rear/tail- light/brakelight bulb, use the following procedure. 425 2411-565 1. Rotate the socket counterclockwise and remove it from the housing. 2. To remove the bulb from the socket, push in and rotate counterclockwise. 3. To install the bulb, push in and turn clockwise. 4. Insert the socket into the housing and rotate it clockwise.
2411-566 Turn Signal Light - Front/ Position Light-Front Always replace a blown fuse with a fuse of the same type and rating. If the new fuse blows after a short period of use, consult an authorized Arctic Cat ATV dealer immediately. CAUTION To replace the front turn signal light/front position light bulb, use the following pro- cedure. 1. Rotate the socket counterclockwise and remove it from the housing. Tools A basic tool kit is provided with the ATV. Maintain the tool kit with the ATV at all times. 2. To remove the bulb from the socket, pull it straight out of the socket. 3. To install the bulb, push it straight into the socket. 4.
Insert the socket into the housing and rotate it clockwise. Fuses The fuses are located in a power distribu- tion module in front of the steering post under the electrical access panel. If there is any type of electrical system failure, always check the fuses first. ACE-033C 60 60 60 60