13. Wiper Switch Panel This panel is only for operation of the upper windshield wiper. When the wiper stops running, it moves to right side of the cabin, resting in its support. NOTE: When the front window is lifted, the wiper motor will not operate. FG000308 Figure 20 Constant Speed Button Pressing the button turns "ON" the windshield wiper. An indicator light above the button will turn "ON" indicating that wiper is "ON". The wiper will run at a constant speed. Pressing the button again, turns "OFF" the windshield wiper. FG000241 Figure 21 Intermittent Speed Button Pressing button once (first time): Windshield wiper runs approximately on a three second intermittent cycle.
The left side indicator light will turn "ON". Pressing button again (second time): Windshield wiper runs approximately on a six second intermittent cycle. The right side indicator light will turn "ON". Pressing button again (third time): Turns "OFF" the windshield wiper. Both indicator lights will be turned "OFF". FG000242 Figure 22 Windshield Washer Button Pressing the washer button will spray windshield washer fluid onto the windshield. Use only the proper windshield washer fluid in the system. NOTE: Do not operate the windshield washer without any fluid. If operate without any fluid, the washer motor may be damaged. Check level in washer tank, and add fluid as required. NOTE:
Using soapy water or synthetic detergent instead of window cleaning fluid, can damage the wiper blade or painted surfaces. Use standard window cleaning fluid: SSK703. FG000243 Figure 23 DX140R/DX140LCR Operating Controls 2-14