Automatic Travel Speed Control WARNING AVOID DEATH OR SERIOUS INJURY Do not change the travel mode while traveling. Always use speed mode "O" when traveling down a slope. It is very dangerous to change to speed modes indicated "I" or "II" while going down a slope. Only change travel mode after coming to a complete stop. Two travel speed ranges can be selected by using the travel speed selector switch on the control panel (Figure 26). "O" (LOW) - In this position low travel speed and a higher torque are selected. O I II "I" (HIGH) - In this position high travel speed and a lower torque are selected.
"II" (AUTOMATIC) - Setting the control at the "II" position enables the machine to change to a different speed range automatically. This change happens automatically depending on the hydraulic oil pressure in the travel circuit. When hydraulic oil pressure rises, the travel speed is automatically set to low. FG000023 Figure 26 An example is if the machine is traveling on a flat, solid surface, the higher speed range would be used. When a slope is encountered, the speed drops and the travel circuit hydraulic pressure rises, causing the control circuit to shift to the higher torque, lower speed range. DX140R/DX140LCR Operation 3-14