To activate breaker 1. Set breaker selector switch to "II" (BREAKER) position. O II I 2. Press lower button on top of right-hand work lever (joystick) to activate hydraulic breaker. 3. Release lower button on top of right-hand work lever (joystick) to deactivate hydraulic breaker. Figure 83 Right-hand Work Lever (Joystick) FG000117 Relief Valve Adjustment 1. Cap pipe on arm end, using a cap capable of handling 350.0 kg/cm 2 (5,000 psi) under the condition of disconnecting hose to hydraulic breaker. 2. Adjust pump pressure using activating the breaker, and watching the pressure displayed on the instrument panel. Press the display selector button to show digital pressure reading.
(A separate pressure gauge is not required.) 3. Adjust the relief valve pressure by turning the adjustment screw of breaker relief valve. The relief valve is installed on the left side of the upper structure behind the boom. (Do not use the overload relief valve on the lower part of control valve for the breaker relief valve.) FG014414 Figure 84 WARNING AVOID DEATH OR SERIOUS INJURY If the relief valve pressure is adjusted while the hydraulic breaker is connected, there is possibility that a high-pressure spike or setting could break a hose or pipe. Personal injury or death could result from a hydraulic hose or pipe failure. DX140R/DX140LCR Operation 3-36