Doosan DX140R/DX140LCR — Operation in Dusty or Sandy Areas

5. Do not park machine in sun for long periods of time. When practical park machine under cover to protect it from sun, dirt and dust. A. Cover inactive machine with tarpaulin if no suitable shelter is available. Protect engine compartment, transmission and hydraulics from entrance of dust. B. In hot, damp, climates corrosive action will occur on all parts of the machine and will be accelerated during the rainy season. Rust and paint blisters will appear on metal surfaces and fungus growth on other surfaces. C. Protect all unfinished, exposed surfaces with a film of preservative lubricating oil. Protect cables and terminals with ignition insulation compound.

Apply paint or suitable rust preventive to damaged surfaces to protect them from rust and corrosion. Operation in Dusty or Sandy Areas Operation of the machine can cause dust in almost any area. However, when in predominantly dusty or sandy areas, additional precautions must be taken. 1. Keep cooling system fins and cooling areas clean. Blow out with compressed air, if possible, as often as necessary. WARNING AVOID DEATH OR SERIOUS INJURY Wear goggles when using compressed air. 2. Use care when servicing fuel system to prevent dust and sand from entering the tank. 3. Service the air cleaner at frequent intervals, check air restriction indicator daily and keep dust cup and dust valve clean.

Prevent dust and sand from entering engine parts and compartments as much as possible. 4. Lubricate and perform services outlined on current lubrication chart on machine and "Lubrication Chart and Table" Section 4. Clean all lubrication fittings before applying lubricant. Sand mixed with lubricant becomes very abrasive and speeds wear on parts. 5. Protect machine from dust and sand as much as possible. Park machine under cover or protect with tarpaulin to keep dust and sand from damaging unit. Operation 3-45 DX140R/DX140LCR