OPERATION MACHINE OPERATIONS AND CONTROLS RECOMMENDED APPLICATIONS In addition to the following, it is possible to further increase the range of applications by using various attachments. Backhoe Work A backhoe is suitable for excavating at a position lower than the machine. When the condition of the machine is as shown in the diagram at right, each cylinder's maximum pushing excavation force is obtained when the bucket cylinder and link, arm cylinder and arm are at 90є. When excavating, use this angle effectively to optimize your work efficiency. The range for excavating with the arm is from a 45єangle away from the machine to a 30є angle toward the machine.
There may be some differences depending on the excavation depth, but try to stay within the above range rather than operat- ing the cylinder is the end of its stroke. Shovel Work A shovel is suitable for excavating at a position higher than the machine. Shovel work is performed by attaching the bucket in the reverse direction. Ditching Work Ditching work can be performed efficiently by attaching a bucket to match the width of the ditch and then setting the tracks parallel to the line of the ditch to be excavated. To excavate a wide ditch, first dig out both sides and then finally remove the center portion. 3-71