MAINTENANCE PROCEDURE MAINTENANCE 1. Pump in grease through grease fitting (5) with a grease pump. 2. To check that the track tension is correct, run the engine at low idling, move the machine forward a distance equal to the length of track on ground, then stop the machine. 3. Check the track tension again, and if the tension is not correct, adjust it again. 4. If the tension is still low after supplied grease, the rubber shoe needs to be replaced or the seal in the cylinder needs to be replaced. Ask your Komatsu distributor for replacement. Loosening track tension It is extremely dangerous to release the grease by any method except the procedure given below.
If the track tension is not relieved by this procedure, please contact your Komatsu distributor. WARNING 1. Loosen plug (4) gradually to release the grease. 2. When loosening plug (4), turn it a maximum of one turn. 3. If the grease does not come out smoothly, move the machine forwards and backwards a short distance. 4. Tighten plug (4). 5. To check that the track tension is correct, run the engine at low idling, move the machine forward a distance equal to the length of track on ground, then stop the machine. 6. Check the rubber shoe tension again, and if the tension is not correct, adjust it again. 4-32