MAINTENANCE MAINTENANCE PROCEDURE Breaker Circuit Additional Oil Filter Element - Replace (If equipped) WARNING The parts and oil are at high temperature after the engine is stopped, and may cause serious burns. Wait for the temperature to go down before cleaning the engine breather. When using compressed air, there is a hazard that dirt may be blown up and cause serious injury. Always use safety glasses, dust mask, or other pro- tective equipment. Prepare a container to catch the oil. 1. Place a container under the filter element to catch the oil. 2. Turn filter case (1) to the left to remove it, then take out element (2). 3. Remove plug (3) from filter case (1). 4.
Clean the removed parts, then install new element (2) and O-ring (4). 5. When installing, bring the case into contact with the filter holder, then tighten a further 1/2 turns. NOTICE When the breaker is used, replace the element every approx 250 hours (when operating ratio is more than 50%), referring to thechart at the right. 4-43