MAINTENANCE PROCEDURE MAINTENANCE Swing Machinery Case Oil - Check/Add WARNING The parts and oil are at high temperature after the engine is stopped, and may cause serious burns. Wait for the temperature to go down before starting the operation. 1. Remove dipstick (G) and wipe the oil from the dipstick with a cloth. 2. Insert dipstick (G) fully in the guide. 3. When dipstick (G) is pulled out, if the oil level is between the H and L marks of the gauge, oil level is proper. 4. If the oil does not reach the L mark on dipstick (G), add engine oil through dipstick insertion hole (F). When refilling, remove bleeding plug (1). 5.
If the oil level exceeds the H mark on the dipstick, loosen drain plug (P) to drain the excess oil. 6. After checking oil level or adding oil, insert the dipstick into the hole and install air bleeding plug (1). 4-54