ATTACHMENTS AND OPTIONS AIR CONDITIONER AIR CONDITIONER MAINTENANCE WARNING If the refrigerant used in the cooler gets into your eyes or on your hands, it may cause loss of sight or frostbite. Do not touch the refrigerant. Never loosen any part of the refrigerant circuit. Do not bring any flame close to any point where the refrigerant gas is leaking. If there is a lack of refrigerant (gas), the cooling performance will be poor. When operating the cooler at high speed with the engine at full throttle, use the receiver sight glass (inspection window) to check the condition of the refrigerant gas (Freon R134a) flowing in the refrigerant circuit. No bubbles in refrigerant flow:
Suitable Some bubbles in flow (bubbles pass continuously): Lack of refrigerant Colorless, transparent: No refrigerant REMARK When there are bubbles, the refrigerant gas level is low, so contact your refrigerant dealer to have refrigerant added. If the air conditioner is run with the refrigerant gas level low, it will cause damage to the compressor. If there is mud or dirt stuck to the condenser fins, there will be a big drop in the cooling efficiency of the condenser. This will cause a drop in the performance of the cooler, so wash off all mud and dirt stuck to the fins. If the fins are crushed, repair them with a screwdriver.
In the off-season also, operate the compressor at low speed for several minutes once a month to supply lubricant to each component of the compressor. (Run the engine at low speed and turn the cooler temperature regulator knob fully to the left.) When the ambient temperature is low, if the compressor is suddenly run at high speed, it will cause failure of the compressor. The compressor is set so that if the ambient temperature is 2.0 to 6.5єC (35.6 to 43.7єF), it will not run even if the cooler switch is turned ON. 6-11