ATTACHMENTS AND OPTIONS AIR CONDITIONER Adjust the fan belt tension. 4. Insert the bar between alternator (7) and the cylinder block to hold alternator (7) in position. When fixing the alternator in position, put a wooden block between the bar and alternator (7) to prevent damage to alternator (7). 5. Loosen bolts (8) and (9). 6. Move alternator (7) with the bar so that the deflection of the belt is approx. 8 mm(0.3in) with a finger force of approx. 58.8 N (6 kgf). 7. Tighten bolts (8) and (9) to secure alternator (7) in posi- tion NOTICE Check each pulley for damage, wear of the V-groove, and wear of the V-belt.
In particular, be sure to check that the V-belt is not touching the bottom of the V- groove. If the belt is stretched and there is no allowance for adjustment, or if it is cut or cracked, please contact your Komatsu distributor for replacement. Install compressor (1). 8. Secure compressor (1) to bracket (6) with bolts (4) and (5). Tightening torque Bolt (4): 59 to 64 N•m (6 to 7.5 kgf•m, 43.4 to 54.2 lbft) Tighten bolt (5) temporarily, then tighten it to the specified torque after adjusting the belt. 9. Secure cover (3) with bolt (2). 10. After installing the compressor, adjust the tension of the compressor belt (next procedure). Adjusting compressor belt 11.
Insert the bar between compressor (1) and the bracket block to hold compressor (1) in position. When fixing the compressor in position, put a wooden block between the bar and compressor (1) to prevent damage to compres- sor (1). 12. Loosen bolts (5) and (10). 13. Move compressor (1) with the bar so that the deflection of the belt is approx. 10 to 12 mm(0.4 to 0.5 in) with a finger force of approx. 58.8 N (6 kgf). 14. Tighten bolts (10) and (5) to secure compressor (1) in position. Tightening torque: 36 to 51 N•m (3.7 to 5.2 kgf•m, 26.8 to 37.6 lbft) 15. Check each pulley for damage, wear of the V-groove, and wear of the V-belt.
In particular, be sure to check that the V-belt is not touching the bottom the V-groove. 16. If the belt is elongated and there is no more allowance for adjustment, or if the belt is cut or cracked, replace the belt. 17. After the V-belt has been replaced, operate for 1 hour, then adjust again. 6-15