Komatsu — LONG TERM STORAGE

MACHINE READY FOR ATTACHMENT ATTACHMENTS AND OPTIONS Hydraulic System - Pressure Release 1. Place the work equipment on the ground. Close the crusher attachment jaws, etc. 2. Stop the engine. 3. Move the safety lock lever to the free position. Move the work equipment control lever and the attachment control pedal to full stroke back and forth, right and left so as to release the pressure in the control circuit. 4. Start the engine again, run it for 2 to 6 seconds, then stop the engine and repeat Step 3. 5. Repeat the operation in Step 4 until no hissing sound of hydraulic pressure can be heard. (Approx. 2 to 3 times) 6.

Set the safety lock lever to the LOCK position, and lock the work equipment levers and attachment control pedal.Note that the pressure cannot be completely released, so if the accumulator inthe control circuit is removed, loosen the screws slowly, and do not stand in the direction where the oil spurts out. LONG TERM STORAGE If the equipment is not to be used for a long time, do as follows. Set the stop valve in the LOCK condition. Install a plug to the valve. Install a plug to the stopvalve. Set the selector valve to the position for general attach- ments such as the crusher. Set the lock pin at the LOCK position.

If there is no breaker or general attachment installed, operating the pedal may cause overheating and other problems. 6-26