Komatsu — CONTROL PATTERN CHANGE PROCEDURE

CHANGING MACHINE CONTROLL PATERN (IF PATTERN CHANGE VALVE EQUIPPED) ATTACHMENTS AND OP- TIONS CHANGING MACHINE CONTROLL PATERN (IF PAT- TERN CHANGE VALVE EQUIPPED) WARNING When changing the operating pattern of the machine, set the machine in the parking posture, stop the engine, check that the safety lock lever is at the LOCK position, then change the operating pattern. To prevent personal injury caused by mistaken operation, test operate the machine and check that the display on the operating pattern card is the same as the movement of the machine. If it is not the same, replace the operating pattern card immediately with the card that matches the operating pattern.

When checking the movement of the machine, check carefully that the surrounding area is safe, and operate slowly. CONTROL PATTERN CHANGE PROCEDURE 1. After setting the machine in the parking posture, set the safety lock lever to the LOCK position, then stop the engine. 2. Open the engine hood. The pattern selector valve is at the side of the oil cooler at the rear left of the machine. 3. Follow the steps explained below, when switching the patterns. 1) Loosen wing nut (1). 2) Turn lever (2) so that portion (A) of the lever is aligned with the control pattern marked on the top surface of the valve. 3) After the switching, tighten wing nut (1). 4.

Change to an operating pattern card (insert it in the holder) that matches the selected operating pattern. 5. Start the engine, set the safety lock lever to the FREE position, operate the work equipment levers slowly, and check that the operating pattern has changed. 6-28