ATTACHMENTS AND OPTIONS AUTOMATIC GREASING SYSTEM 3. Select the code number for the desired greasing interval (time) "a" from the automatic greasing setting code table. 4. Press controller panel switch (1) and switch (2) at the same time. "a" flashes on the display of LED (3) and setting lamp (4) flashes. If the display of LED (3) is "b" or "c", press switch (2) until the display of LED (3) becomes "a". 5. When the display of LED (3) becomes "a", press switch (1). "a" and the code number for the present setting are displayed in turn by LED (3). 6. When the code number for the selected greasing interval is displayed, press switch (2).
When switch (2) is pressed, the code number goes up in turn. 7. Press switch (5). "b" flashes on the display of LED (3). 8. Press switch (6) two times. A small dot "." flashes on the display of LED (3). This completes the setting. REMARK To check the setting visually, repeat the above Steps 4 and 5, and if there is no mistake in the setting, press switch (6) two times to make the small dot "." flash on the display of LED (3). Automatic greasing setting code table Note 1: Do not use the values marked "-" for the code number. Note 2: When the machine is shipped from the factory, the code number for the controller is set at a = 6, b = 6, c =0. Do not change the settings for b or c.
If the settings for b or c are changed, an abnormality display may appear during operations and the automatic greasing may not be carried out. 6-33 Setting item No. Code No. 0 1 2 3 4 5 6 7 8 9 a Greasing interval (time) — 1 1.5 2 3 4 5 6 8 — b Pressure hold time (minutes) — — — — — — 15 — — — c — ∞ — — — — — — — — —