Komatsu — CONTROLLER

ATTACHMENTS AND OPTIONS AUTOMATIC GREASING SYSTEM 6. Press the grease cartridge slightly so that grease comes out from the mouth, then screw the cartridge (approx. 5 turns) securely into suction port mouthpiece (5). 7. Tighten tank cover (1)(approx. 1/3 turns) securely until the lock is engaged. Select the grease from the following table according to the ambient temperature. *1: There are two types of automatic greasing cartridges available: the standard type (NLGI No. 2) and the cold area type (NLGI No. 0). When changing the automatic greasing cartridge from the standard type to the cold area type, or from the cold area type to the standard type, please contact your Komatsu distributor.

Unless otherwise specified, a standard cartridge (NLGI No. 2) is installed when the machine is shipped from the factory. The part numbers are as follows. Standard cartridge: 20Y-70-25480 Cold area cartridge: 20Y-70-25490 When ordering the cartridge, check the part number in the parts book. *2: If the cold area type grease (NLGI No. 0) is used in warm areas, some grease will drip from the ends of the work equipment pins, but there is no problem in the lubricating performance. 6-35