Komatsu — 24.9.1 CHANGE OIL IN HYDRAULIC OIL TANK, REPLACE HYDRAULIC FILTER ELEMENT

MAINTENANCE 24.9 EVERY 2000 HOURS SERVICE Maintenance for every 50, 100, 250, 500 and 1000 hours should be carried out at the same time. 24.9.1 CHANGE OIL IN HYDRAULIC OIL TANK, REPLACE HYDRAULIC FILTER ELEMENT WARNING ! The oil will be hot if the machine was just operated. Wait for the oil to cool down before changing it. ! When removing the oil filler cap turn it slowly to release the internal pressure, then remove it carefully. 1 Lower the bucket to the ground and apply the parking brake, then turn OFF the engine. 2 Remove bolts, (1) then remove cover. (2) 3 Keep knob (A) of oil filler port (F) pulled, then turn the cap counterclockwise and remove it.

4 Set a container to catch the oil under drain plug (3). 5 Remove drain plug (3) to drain oil. 6 After draining the oil, tighten drain plug (3). 7 Remove the mounting bolt of filter cover (4), then remove the covers. While doing this the cover could fly off from the force of spring (5), so hold the cover down while removing the bolts. 8 Remove spring (5) and bypass valve (6), then remove element (7). 9 Check to be sure there is no foreign matter inside the tank before cleaning it. 10 Install a new element, then install by pass valve (6),spring (5) & cover (4). If the O-ring of the cover is damaged or deteriorated, replace it with a new part.

11 While installing the cover bolts, hold down the cover and tighten the bolts evenly. 3-61