Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

MBE 4000 SERVICE MANUAL 2. Protect the crankshaft with a rag, then using a screwdriver, press out the radial seal. See Figure 1-40. 1. Rear Radial Seal 3. Heavy Cloth 2. End of Crankshaft 4. Screwdriver Figure 1-40 Removing the Rear Radial Seal 1.8.2 Rear Radial Seal Installation Install the rear radial seal as follows: NOTE: The radial seal does not need to be lubricated. 1. Inspect the contact surface of the flywheel for damage and wear. If it is scored or worn, replace it. 2. Place the receptacle,(J 45393 or 457 589 02 15 00), on the end of the crankshaft. Put the new radial seal in place on the rear seal installer, (J 45393 or 457 589 02 15 00).

All information subject to change without notice. 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION 1-55