1.9 CRANKSHAFT ASSEMBLY 1.9.1 Crankshaft Removal Remove the crankshaft as follows: 1. Remove the engine. FALLING ENGINE To avoid injury from a falling engine, an adequate lifting device with a spreader bar and sling should be used to lift the engine. The sling and spreader bar should be adjusted so the lifting hooks are vertical to prevent bending the lifter brackets. To ensure proper weight distribution, all provided lifter brackets must be used. FALLING ENGINE To avoid injury from a falling engine, ensure the engine is securely attached to the engine overhaul stand before releasing the lifting sling. 2. Mount the engine on an engine stand. 3. Remove the cylinder heads.
Refer to section 1.2.1. 4. Remove the oil pan and oil pump. Refer to section 3.1.1. Refer to section 3.4.1. 5. Remove the flywheel and flywheel housing. Refer to section 1.12.1. 6. Remove the front cover housing. Refer to section 1.10.1. 7. Remove the pistons. Refer to section 1.17.1. All information subject to change without notice. 1-58 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION