1.9 CRANKSHAFT ASSEMBLY 13. Lift the crankshaft out of the cylinder block. Make sure the crankshaft doesn't twist from side to side. See Figure 1-46. 1. Crankshaft 3. Hook of Hoisting Chain 2. Flexible Straps 4. Cylinder Block Figure 1-46 Lifting the Crankshaft [a] Lower the crankshaft gently onto a flat surface covered with clean cardboard. [b] Remove the hoist. 14. Mark each upper bearing shell and its corresponding race before removing the bearing shells from the crankcase. 15. Check all parts for wear or damage. Measure the various crankshaft specifications. Refer to section 1.9.2.3. 1.9.2 Crankshaft Installation Install the crankshaft as follows: 1.
Clean the crankshaft oil passages with a wire brush and blow compressed air through the passages. Clean the crankshaft, bearings, and bearing seats with a chamois. 2. Lubricate the bearing surfaces with a light coating of clean engine oil. All information subject to change without notice. 1-62 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION