1.11 CRANKSHAFT VIBRATION DAMPER 1.11 CRANKSHAFT VIBRATION DAMPER A special tool, Engine Cranking Tool (J 46167 or 407 589 00 63 00) is required for this procedure. 1.11.1 Crankshaft Vibration Damper Removal Remove the crankshaft vibration damper as follows: 1. Remove the drive belts from the alternator, coolant-pump, idler, and air-conditioner compressor pulleys, as installed. Refer to section 8.1. 2. Remove the inspection cover from the flywheel housing and install the engine cranking tool (J 46167 or 407 589 00 63 00), with the locking pin in place. Refer to section 1.15.2. 3.
To gain access to the vibration damper, remove the lower mounting bolts from the bottom of the front fairing/bumper. 4. Remove the mounting bolts from the vibration damper. Drop the vibration damper down below the radiator and remove it from the engine. See Figure 1-62. 1. Vibration Damper 3. Oil Deflector 2. Mounting Bolt 4. End of Crankshaft Figure 1-62 Vibration Damper Removal 5. Remove the oil deflector from the crankshaft. All information subject to change without notice. 1-84 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION