1.12 FLYWHEEL 1.12 FLYWHEEL Three special tools are required for this procedure. They are: Engine Cranking Tool (J 46167 or 407 589 00 63 00) 19-mm Flywheel and Main Pulley Socket (J 45390 or 422 589 02 09 00) Flywheel Guide Studs (set of 2) (904 589 02 63 00) 1.12.1 Flywheel Removal Remove the flywheel as follows: 1. Remove the transmission. 2. Remove the clutch from the flywheel. 3. Remove the crank angle position sensor from the flywheel housing. See Figure 1-63. Refer to section 2.6.3. 1. Crank Angle Position Sensor 2. Camshaft (TDC) Sensor Figure 1-63 Crank Angle Position Sensor Removal 4.
Remove the inspection cover from the flywheel housing and install the engine cranking tool (J 46167 or 407 589 00 63 00). Insert the pin and make sure the tool is blocked. Refer to section 1.15.2. All information subject to change without notice. 1-86 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION