Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

1.13 RING GEAR 3. Check the amount of interference fit between the flywheel mounting shoulder and the ring gear. See Figure 1-73. The interference fit must be within the permissible values listed in Table 1-23. 1. Ring Gear 2. Flywheel Figure 1-73 Flywheel/Ring Gear Interference Fit Table 1-23 Flywheel Ring Gear Specifications [a] Measure the flywheel shoulder diameter (B). [b] Measure the inside diameter of the new ring gear (A). [c] Determine the amount of interference fit by subtracting the ring gear inside diameter (A) from the flywheel shoulder diameter (B). [d] Make sure that the amount of interference fit lies between 0.295 and 0.645 mm (0.0116 and 0.0254 inch).

All information subject to change without notice. 1-98 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION Description Specification, mm (in.) Flywheel Shoulder Diameter (for ring gear mounting) 432.450-432.645 mm (17.0256-17.0332 inches) Hole for Mounting Clutch Pressure Plate M10 x 1.5 Ring Gear Inside Diameter 432.000-432.155 mm (17.0078-17.0139 inches) Ring Gear/Flywheel Interference Fit 0.295-0.645 mm (0.0116-0.0254 inch) Ring Gear/Flywheel Permissible Radial Runout 0.5 mm (0.02 inch) Ring Gear Width 18.4-18.6 mm (0.72-0.73 inch) Ring Gear Fitting Temperature 200-230 C (390-450 F)