1.17 PISTON, PISTON RING, AND CONNECTING ROD 1.17 PISTON, PISTON RING, AND CONNECTING ROD The pistons are made of aluminum alloy with ring carriers and a shallow combustion chamber recess. The pistons are cooled by oil spray nozzles. See Figure 1-79 for an exploded view of the piston and connecting rod assembly. 1. Piston and Rings 5. Bearing Cap 2. Wrist Pin 6. Connecting Rod Stretch Bolt 3. Snap Ring 7. Bearing Shell 4. Connecting Rod Figure 1-79 Piston Assembly (exploded view) 1.17.1 Piston Removal Remove the piston assembly as follows: 1. Remove the engine from the vehicle. NOTE: The MBE 4000 engine has individual heads for each cylinder.
To remove one piston, do these procedures step by step. To remove all the pistons, repeat each step in these instructions, as applicable, for all six pistons. 2. Remove each cylinder head, as required. Refer to section 1.2.1. 3. Remove the oil pan. Refer to section 3.1.1. All information subject to change without notice. 1-106 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION