Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

1.17 PISTON, PISTON RING, AND CONNECTING ROD 10. Measure the connecting rod stretch bolts. Replace any bolts that exceed the maximum length of 68.5 mm (2.70 inches). See Figure 1-87. Lubricate the stretch bolt threads with a light coating of engine oil. 1. Shank Figure 1-87 Measuring a Stretch Bolt 11. Install the bearing cap on the connecting rod and hand-tighten the stretch bolts. Be sure that the marks on the cap and the rod match. See Figure 1-80. 12. Tighten the M16 x 1.5 connecting rod stretch bolts alternately. Tighten each one in turn to the first stage and then go on to the next stage. Listed in Table 1-24. Table 1-24 Tightening Stages, Connecting Rod Stretch Bolts 13.

Check the connecting rod end play (axial play). Refer to section 1.17.3.2. 14. Rotate the crankshaft to make sure it turns freely. NOTE: If it is necessary to turn the crankshaft and the flywheel has been removed, install the flywheel guide studs in the crankshaft gear. All information subject to change without notice. 1-114 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION Max. Shaft Length Tightening Stage Torque Value 68.5 mm (2.70 in.) Stage 1 100-115 N·m (74-85 lb·ft) Stage 2 additional 90-100