MBE 4000 SERVICE MANUAL 3. Install the two matched halves of the bearing shell, as marked on removal, into the connecting rod and into the bearing cap. Be sure the locking lugs on the bearing shells fit into the grooves in the rod and cap. See Figure 1-99. 1. Connecting Rod 3. Bearing Cap 2. Bearing Shell (2 halves) 4. Connecting Rod Bolt Figure 1-99 Bearing Shell Replacement 4. Install the bearing cap on the connecting rod, pressing it on by hand. Be sure that the marks on the cap and rod match. 5. Lubricate the threads and the contact surface of the head of each stretch bolt with a light coating of engine oil. 6.
Install the stretch bolts in the connecting rod, and tighten them alternately. Tighten each one in turn to the first stage and then go on to the next stage, listed in Table 1-29. Table 1-29 Tightening Stages, Connecting Rod Stretch Bolts All information subject to change without notice. 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION 1-127 Max. Shaft Length Tightening Stage Torque Value 68.5 mm (2.70 in) Stage 1 108 N·m (80 lb·ft) 68.5 mm (2.70 in) Stage 2 additional 90 degrees