Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

1.17 PISTON, PISTON RING, AND CONNECTING ROD 9. Set the caliper (internal measurement 80 to 100 mm) to the nominal bearing-journal diameter calculated above. Use a 75 to 100 mm micrometer for the setting. Preload the setting 5 mm (0.2 inch). See Figure 1-101. Figure 1-101 Setting the Caliper 10. Using a quick-release caliper (internal measurement 80-120 mm), dial gauge, and holder, measure the inside diameter of the bearing bore (with the shells installed) at three points. All information subject to change without notice. 1-130 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION