1.19 VALVES 7. If the value measured is within the range given in the "Check For" column listed in Table 1-36, check the next valve. Table 1-36 Valve Lash Checking and Adjustment If the value measured is outside the range given in the "Check For" column listed in Table 1-36, adjust the valve lash. 1.19.2.2 Method Two — Adjust All Valves Using Two Crankshaft Positions Method two allows you to adjust all the valves using just two crankshaft positions. NOTE: Clean each cylinder head cover before removing it. 1. Remove the cylinder head covers. See Figure 1-112. Refer to section 1.1.1. 1. Socket-Head Bolt 3. Gasket 2. Cylinder Head Cover 4.
Cylinder Head Figure 1-112 Cylinder Head Cover, (exploded view) 2. Remove the inspection cover on the flywheel housing. All information subject to change without notice. 1-146 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION Valve Type Check For: mm (inches) Adjust to: mm (inches) Intake 0.30 to 0.60 (0.012 to 0.024) 0.40 (0.016) Exhaust 0.50 to 0.80 (0.020 to 0.032) 0.60 (0.024)