Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

1.20 EGR VALVES 8. Lubricate the valve stem and valve stem seal installer/protector (J 46174) with a light coating of clean engine oil. 1. Valve Stem Seal 3. Valve Guide 2. Valve Stem 4. Valve Stem Sealing Ring (installed) Figure 1-126 Valve Stem Seal and Sealing Ring Replacement NOTE: The installer/protector prevents the groove on the valve stem from damaging the valve stem seal. 9. Push the valve stem seal installer/protector (J 46174) over the valve stem until it makes contact with the valve. 10. Slide the valve stem seal over the installer/protector and the valve stem. Using fingers, press valve stem seal into place until the seal seats on the valve guide. 11. Remove J tool, J 46174. 12.

Using valve guide seal installer (J 46184) and the appropriate hammer, drive the valve stem seal on the guide. NOTE: Check the seal to make sure it is correctly seated on the valve guide. 13. Remove the installer from the valve stem seal and the valve. 14. Install the keeper, spring retainer, valve spring and spring seat, as removed. 15. Repeat the procedure for the other valves. All information subject to change without notice. 1-164 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION