Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

1.22 CAMSHAFT AND CAMSHAFT SENSOR 14. Pull the tappets (valve lifters) out of the block. Mark the tappets, in order, as removed. See Figure 1-133. 1. Cylinder Block 3. Tappet (valve lifter) 2. Camshaft Entry Hole 4. Fuel Pump Driven Gear Figure 1-133 Removing the Tappets 15. Clean and inspect the tappets. Replace the tappets if there are signs of damage or wear, or if any of the measurements do not meet the specifications listed in Table 1-49. Table 1-49 Valve Tappet Specifications [a] Measure the outside diameter of each tappet. [b] Measure the diameter of the tappet housing in the cylinder block. 16. Inspect the camshaft. Refer to section 1.22.2.1.

All information subject to change without notice. 1-174 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION Description Repair Stage Specifications, mm (inch) Tappet Outside Diameter Standard 29.931-29.952 (1.1784-1.1792) Tappet Outside Diameter Repair Stage I 30.444-30.465 (1.1986-1.1994) Tappet Housing Diameter (in cylinder block) Standard 30.000-30.021 (1.1811-1.1819) Tappet Housing Diameter (in cylinder block) Repair Stage I 30.500-30.525 (1.2008-1.2018)