Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

1.22 CAMSHAFT AND CAMSHAFT SENSOR 6. Install the fuel pump drive gear on the front of the camshaft, as removed. Torque the bolts to 60 N·m (44 lb·ft.) 7. Turn the engine on the stand until it is right side up. 8. Install the unit pumps. Refer to section 2.1.2. 9. Install the camshaft front cover on the cylinder block, as removed. Torque the mounting bolts to 50 N·m (37 lb·ft.) 10. Install the fan support. 11. Install the vibration damper. Refer to section 1.11.2. 12. Lubricate the pushrods with a light coating of clean engine oil. Install the pushrods and the rocker arm assembly. Refer to section 1.21.4.

FALLING COMPONENT To avoid injury from a falling component, ensure a proper lifting device is used. 13. Remove the engine from the stand and install it on the vehicle. 14. Fill the engine with oil. 1.22.2.1 Camshaft Inspection Inspect the camshaft as follows: NOTE: To get a correct hardness reading, it is critical to place a hard base below the cam or bearing journal. All information subject to change without notice. 1-176 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION