2.1 INJECTOR UNIT PUMP 3. Disconnect the engine wiring harness from the injector unit pump. See Figure 2-2. 1. Engine Wiring Harness 3. Terminal Screw 2. Terminal 4. Injector Unit Pump Figure 2-2 Unit Pump Electrical Wires To avoid injury from the sudden release of a high-pressure hose connection, wear a face shield or goggles. PERSONAL INJURY 4. Remove the high-pressure fuel injector line. Refer to section 2.3.1. 5. Disconnect the fuel line at the fuel gallery inlet. Have a suitable container ready to catch any fuel that comes out of the cylinder block or fuel line. All information subject to change without notice. 2-4 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION