2.7 DDEC ELECTRONIC CONTROL UNIT 5. Rotate the safety latch down to release the engine wiring harness connector and disconnect it from the DDEC-ECU unit. See Figure 2-20. 1. Engine Wiring Harness 3. Engine Electrical Connector 2. Safety latch Figure 2-20 Engine Electrical Connector 6. Remove the mounting bolts and rubber spacers holding the DDEC-ECU control unit to the engine. Then remove the unit. NOTE: Do not disassemble the DDEC-ECU control unit. It cannot be serviced. 2.7.2 DDEC Electronic Control Unit Installation Install the DDEC-ECU Control Unit as follows: 1. Position the spacers, DDEC-ECU control unit, and mounting bolts on the cylinder block, as removed. 2.
Install the DDEC-ECU control unit on the cylinder block. Tighten the mounting bolts 15 N·m (11 lb·ft). 3. Install the fuel heat exchanger on the DDEC-ECU and tighten the mounting bolts 8 N·m (6 lb·ft). 4. Connect the vehicle wiring harness to the DDEC-ECU. Pull down on the locking unit to lock it in place. All information subject to change without notice. 2-32 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION