3.4 OIL PUMP 3.4.4 Oil Pump Installation Install the oil pump assembly as follows: 1. Coat the contact surface between the block and the oil pump with Loctite 574. 2. Position the oil pump on the cylinder block. Make sure the teeth on the drive wheel of the oil pump mesh with the teeth of the crankshaft drive gear. Tighten the oil pump mounting bolt 35 N·m (26 lb·ft). NOTE: It may be necessary to rock the pump counterclockwise so the teeth of the drive wheel can properly align with the crankshaft drive gear. 3. Install the pressure limiting valve on the oil pump. Tighten the valve mounting bolt 35 N·m (26 lb·ft). 4. Install the sump pipe. Tighten all mounting bolts 25 N·m (18 lb·ft).
[a] Install the sump pipe bracket on the cylinder block. [b] Install the sump pipe, with a new gasket, on the oil pump. 5. Install the oil pan with a new gasket. Refer to section 3.1.2. 6. Fill the engine oil circuit. PERSONAL INJURY Diesel engine exhaust and some of its constituents are known to the State of California to cause cancer, birth defects, and other reproductive harm. Always start and operate an engine in a well ventilated area. If operating an engine in an enclosed area, vent the exhaust to the outside. Do not modify or tamper with the exhaust system or emission control system. 7. Start the engine and check for leaks. 8. Check the engine oil level and add oil if necessary.
All information subject to change without notice. 3-20 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION