3.6 OIL FILTER 2. Unscrew the cap and filter and allow the oil to drain into the housing. After draining, remove the assembly from the housing. See Figure 3-19. 1. Oil Filter Cap 3. Oil Filter Housing 2. O-ring Figure 3-19 Oil Filter Element Replacement 3. Remove the element by pressing and twisting the side and detaching it from the cap. 4. Remove the oil filter O-ring and discard it. Lightly grease a new O-ring with engine oil and install it. 5. Insert a new filter element into the housing. 6. Install the cap on the filter and tighten the cap nut 25 N·m (18 lb·ft). All information subject to change without notice. 3-24 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION