3.7 OIL HEAT EXCHANGER AND FILTER HOUSING 3.7 OIL HEAT EXCHANGER AND FILTER HOUSING Perform the following procedures for removal and installation of the oil heat exchanger and filter housing. 3.7.1 Oil Heat Exchanger and Filter Housing Removal Remove the oil heat exchanger and filter housing as follows: HOT COOLANT To avoid scalding from the expulsion of hot coolant, never remove the cooling system pressure cap while the engine is at operating temperature. Wear adequate protective clothing (face shield, rubber gloves, apron, and boots). Remove the cap slowly to relieve pressure. 1. When the engine is cool, drain the coolant from the radiator. 2. Remove the turbocharger from the engine. 3.
Disconnect the coolant pump shunt line from the coolant pump inlet pipe and move it out of the way. 4. Remove the oil filter cap. Inspect the O-ring and filter for damage and replace them if necessary. Drain the oil remaining in the filter into a clean container. 5. Disconnect the wiring harness from the oil pressure/temperature sensor. All information subject to change without notice. 3-26 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION