3.8 OIL PRESSURE AND TEMPERATURE SENSOR 3.8 OIL PRESSURE AND TEMPERATURE SENSOR Perform the following procedures for removal and installation of the oil pressure and temperature sensor. 3.8.1 Oil Pressure and Temperature Sensor Removal Removal the oil pressure and temperature sensor as follows: 1. Loosen the oil filter cap. Lift up the cap and filter to allow the oil to drain. Inspect the O-ring for damage and replace if necessary. 2. Disconnect the wiring connector from the oil pressure/temperature sensor. See Figure 3-24. Figure 3-24 Sensor Installation 3. Remove the oil pressure/temperature sensor.
3.8.2 Oil Pressure and Temperature Sensor Installation Install the oil pressure and temperature sensor as follows: 1. Position the oil pressure/temperature sensor and install the mounting screws. Tighten the fasteners 10 N·m (7 lb·ft). 2. Connect the wiring harness at the oil temperature sensor. 3. Using a new O-ring (if necessary), install the oil filter cap. Tighten the nut 25 N·m (18 lb·ft). All information subject to change without notice. 3-32 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION