MBE 4000 SERVICE MANUAL 4.1 COOLING SYSTEM 4.1.1 Cooling System Draining and Flushing Drain and flush the cooling system as follows: HOT COOLANT To avoid scalding from the expulsion of hot coolant, never remove the cooling system pressure cap while the engine is at operating temperature. Wear adequate protective clothing (face shield, rubber gloves, apron, and boots). Remove the cap slowly to relieve pressure. 1. Open the cap on the surge tank slowly, to allow excess pressure to escape. Set the cap aside. See Figure 4-1. 1. Cap 3. Low-Coolant- Level Probe 2. Surge Tank Figure 4-1 Surge Tank 2. Open the water regulating valve for the heating system.
All information subject to change without notice. 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION 4-3