4.2 COOLANT PUMP 6. Measure the gap between the impeller and the coolant pump housing. This gap, listed in Table 4-4, must be more than 0.6 mm (0.023 inch) and less than 1.0 mm (0.039 inch). See Figure 4-11. Table 4-4 Coolant Pump Assembly, Critical Dimension 1. Impeller 2. Coolant Pump Housing Figure 4-11 Gap Between the Impeller and the Housing 7. Rotate the coolant pump drive shaft to make sure it moves easily and freely. 8. Install the coolant pump on the engine. 4.2.4 Coolant Pump Installation Install the coolant pump as follows: 1. Install the coolant pump on the cylinder block. Install a new gasket. Tighten the mounting bolts 30 N·m (22 lb·ft). 2.
Connect the inlet pipe to the coolant pump housing, as removed. Install a new gasket on the mating surface between the inlet pipe and the coolant pump housing. Tighten the inlet pipe mounting bolts 50 N·m (37 lb·ft). All information subject to change without notice. 4-18 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION Description mm (inch) Gap Between the Impeller and the Coolant Pump Housing 0.6-1.0 (0.023-0.039)