Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

MBE 4000 SERVICE MANUAL 6.1 INTAKE MANIFOLD Perform the following procedures for removal and installation of the intake manifold. 6.1.1 Intake Manifold Removal Remove the intake manifold as follows: 1. Apply the parking brakes, shut down the engine, and chock the rear tires. Tilt the hood. PERSONAL INJURY To avoid injury before starting and running the engine, ensure the vehicle is parked on a level surface, parking brake is set, and the wheels are blocked. 2. Remove the intake air inlet pipe. Discard the inlet pipe gasket. See Figure 6-1. 1. Intake Manifold 3. Intake Air Inlet Pipe 2. Inlet Pipe Gasket 4. Manifold Mounting Bolt Figure 6-1 Manifold Removal and Installation 3.

Remove the bolts from the engine trim cover. Move the side panels down and out of the way to expose the manifold mounting bolts. All information subject to change without notice. 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION 6-3