7.2 EXHAUST BRAKE ASSEMBLY 1. Install the rear bushing in the bracket side of the exhaust brake valve housing. See Figure 7-4. 1. Front Bushing (on shaft) 4. Exhaust Brake Valve 2. Brake Valve Housing 5. Shaft 3. Valve Mounting Bolt (2 qty.) 6. Rear Bushing Figure 7-4 Bushing Alignment [a] Lubricate the rear bushing with a light coating of bearing grease. [b] Using a suitable drift, press in the bushing. Allow the bushing to project slightly into the valve housing bore. 2. Measure bushing projection (dimension B, listed in Table 7-2.) Table 7-2 Bushing Alignment Specifications [a] Choose a feeler gauge equal to dimension B, 2.6 mm (0.10 inch).
[b] Insert the feeler gauge into the bore in the brake valve housing until it is touching the rear bushing. All information subject to change without notice. 7-10 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION Description mm (inch) Distance Between the Two Projecting Bushings (Ref. A) 84.2 (3.31) Projection of the Rear Bushing into the Brake Valve Housing (Ref. B) 2.6 (0.10)