Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

7.2 EXHAUST BRAKE ASSEMBLY [b] Measure the length, listed in Table 7-3, of the uninstalled pneumatic cylinder, for specified preload after installation. See Figure 7-5, measurement B. 1. Pneumatic Cylinder 2. Ball Joint Figure 7-5 Exhaust Brake Assembly Table 7-3 Length of Installed and Uninstalled Exhaust Brake Assembly [c] With the valve open, turn the ball socket (on the cylinder) until it sits right on top of the ball stud (on the adjusting lever). [d] Measure the length of the installed pneumatic cylinder. See Figure 7-5, measurement A. [e] With the valve still open, turn the ball socket over two full turns.

[f] Using high temperature resisting grease, fit the ball socket onto the ball stud, and install the locking element. [g] Tighten the locknut 25 N·m (18 lb·ft). 9. Install the exhaust brake assembly on the engine. All information subject to change without notice. 7-12 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION Designation Measurement, mm (inch) Length of installed pneumatic cylinder 187.0 mm (7.36 in.) Length of uninstalled pneumatic cylinder, for specified preload after installation 183.50 - 184.50 mm (7.22 - 7. 26 in.)