Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

7.3 EGR EXHAUST MANIFOLD 7.3 EGR EXHAUST MANIFOLD The EGR exhaust manifold is a three-piece manifold. The manifold assembly is assembled apart from the cylinder heads, then the entire assembly is installed to the heads. 7.3.1 EGR Exhaust Manifold Removal Remove the EGR exhaust manifold as follows: NOTE: Although not shown in the below graphic, the heat exchanger and heat exchanger bracket are still installed on the engine before the exhaust manifold is removed. 1. Remove the bolt that attaches the smaller front heat shield to the main heat shield, then remove the three bolts attaching the shield to the bottom of the exhaust manifold. Now remove the heat shield. See Figure 7-6. 1.

Upper or Main Heat Shield 2. Lower or Front Heat Shield Figure 7-6 Removal or Installation of the Exhaust Manifold Front Heat Shield NOTE: Upper or main heat shield must remain on the exhaust manifold assembly until the assembly is removed due to inaccessibility of some of the heat shield mounting bolts. All information subject to change without notice. 7-14 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION